Colorificio Sammarinese Biosistem Therm white water-based paint with glass microsphere for indoor use

General data White mural paint with thermo insulating effect. Touching the dry film of the paint there will be a sense of warmth right away, owed to the low exchange of warmth with the wall. This means that the temperature on the surface differs from the one on the inside of the wall, respect to which it is some degrees higher. This effect sensibly reduces the condensate and allows a lower heat dispersion to the outside. If then the condensate phenomena is so imposing you cannot completely avoid it.

Furthermore the product has following characteristics:

• Good hiding power

• Sound-absorbing power

• Anti-condensate power

• Transpiring power

Technical features (data gathered at the temperatur Technical features e at 20°C, U.R. 65%)

• Brookfield viscosity cps. 1600 ± 200
• Specific gravity C0022 Kg/l 1,020± 0,040
• Ph C0030 8±0,5
• Solids % 44±2
• Theoretical spreading rate mq/l 3 - 4 (smooth finishing) 2 (orange peel finishing)
• Appearance of the film  ENISO13300 Gloss 4,0 (very matt)
• Dry in depth Hours 24-48
• Grain size ENISO13300 µm > 100; <300 (average)
• Resistance to wet brushing ENISO13300 Class 3

Application modalities

• Environmental conditions: Environment temperature min + 5 ° C / max + 35 ° C R.H. <80%

              and support conditions: Support temperature min + 5 ° C / max + 35 ° C R.H. <10%

• Thinner Water 
• Method of application Roller, Brush
• Dilution Brush10-15%, Roller 3-5% Mix well the product, slowly adding water to obtain the desired application viscosity.
• Theoretical coverage 10-12 sqm/l for coat, depending on the absorption of the support. Apply two or more coats until obtaining a thickness of more than 200 microns.
• Clean tools with water immediately after use
• Time between coats 6-8 hours